Bed Rail
Side View
Bulkhead
Front Header
Rear Header
Header Stop
Trigger Latch
NOTE:
We recommend closing the
tailgate first and then closing the cover.
Retainer Loop
Retainer Strap
Retainer Hook
15
12
13
To connect the cover assembly (C) to the side rails (A and
B), place the bolt (L) through the oblong hole in the side
rails. Secure the cover assembly by installing a washer (M) and a
hex nut (N) underneath the side rails at the cab with a 1/2” socket.
Place the cover (C) on the side rails towards the front of
the truck bed (near the cab). The front header seal is de-
signed to help shed water and should sit on top of the bulkhead.
14
On the cover assembly (C), identify the driver and
passenger front header end plugs. Remove both plugs
by pulling them outward as shown below.
Install the bolts (L) by sliding them into the header as
shown below. Do this on both driver and passenger sides.
Then reinstall both end plugs.
TruXedo Inc.
• 2209 Kellen Gross Drive Yankton, SD 57078 • 877-878-9336 • truxedo.com ©TruXedo Inc., 2022
Part# 1118736 Rev. A 4-8-22
Place the rear header into the header stops which are
located on both side rails. Rotate the rear header down-
wards until you feel the cover latch in place.
A clicking sound
will indicate a correctly installed cover.
16
17
Disengage the retainer hooks from the retainer loops
and unroll the cover towards the tailgate.
