Truvox International Multiwash Pro 240, User Manual, Page: 5 / 19

product development and we reserve the right to alter
specifications without prior notice.
RECOMMENDED SPARES & ACCESSORIES
FAULT DIAGNOSIS
The following simple checks may be performed by the operator. If the machine is still not working, please contact your local Service Agent:
* If the fuse blows several times, the machine should be checked by an authorised Service Agent.
PLEASE REFER TO THE BACK OF THE MANUAL FOR PICTORIAL INSTRUCTIONS
5 09-21
Item MWPRO240 MWPRO340 MWPRO440
Standard brush – black (PK of 2) 90-0727-0000 90-0728-0000 90-0729-0000
Standard brush – yellow (PK of
2) - 90-0871-0000 -
Standard brush – blue (PK of 2) - 90-0874-0000 -
Standard brush – green (PK of 2) - 90-0877-0000 -
Standard brush – red (PK of 2) - 90-0880-0000 -
Soft brush – grey (PK of 2) 90-0730-0000 90-0731-0000 90-0732-0000
Side brush – black(1 required) 90-0722-0000 90-0723-0000 90-0724-0000
Hard brush – blue (PK of 2) 90-0733-0000 90-0734-0000 90-0735-0000
Escalator brush – blue (PK of 2) 90-1019-0000 90-1020-0000 90-1021-0000
7 litre tank 90-0726-0000
Trolley (for all models) 05-4779-0000
Trouble Reason Remedy
Machine fails to start – no
power
•
Transport working lever is in bottom
position (see picture 2 on page 18)
•
Change to operating position (see pictorial guide)
•
Motor overload protector has tripped
•
Wait for 1 hour to allow the motor temperature
to reach room temperature. Then try again.
•
Transport wheels not raising off the
ground when handle lowered
•
Check for debris and clean machine.
•
Lack of voltage / electrical supply
•
Check fuse *, power cord, plug and socket outlet
Machine fails to pick up water
from the floor
•
Incorrectly fitted / damaged recovery tank
•
Refit or replace recovery tank
•
Worn brushes
•
Check brush pressure, if needed replace brushes.
•
Drum not rotating
•
See below
Drum not rotating
•
Debris around drum or base of machine
•
Clean drum and base of the machine.
Drum is rotating, but brushes
are not
•
Debris around brushes
•
Clean or replace brushes
Machine fails to spray
solution onto the floor
•
Faulty pump
•
If there is no noise present from the pump, check
that the pump cable is fitted correctly.
•
Improper water hose connection
•
Check the quick lock connector for proper fitting
•
No solution in solution tank
•
Fill solution tank
•
Blocked jet
•
Clean jet
•
Blocked inline filter
•
Clean inline filter
•
Blocked filter or faulty valve in solution
tank
•
Clean / replace filter or valve
Motor makes a humming
noise but does not turn
•
Debris around drum and base of the
machine
•
Clean drum and base of machine
The machine is vibrating
•
Bristles on the brushes are deformed
•
Soak brushes in a bucket of water
•
Replace both brushes