13
PREPARATION FOR USE FOR THE ULTRASONIC MODE
Connect the hand piece to the power adaptor, then connect the power adaptor to a power outlet. Press the On/Off button.
There will be a beep and the LED display will show functions and time of use (default time of 15 minutes will display).
INSTRUCTIONS, DIRECTIONS FOR USE, &
OPERATING INSTRUCTIONS FOR THE ULTRASONIC MODE
The treatment head must be pressed flat against the skin.
For your Lux Renew device to operate properly, a conductive solution is needed when using the ultrasonic mode.
Therefore, it is important to first apply water or a water-based gel to the skin areas to be treated.
Apply vibration treatment for four minutes at each treatment site. You may use it longer if you wish. (4 minutes is a
minimum guideline.)
• With your Lux Renew switched on, press MODE repeatedly to select Sonic in
the display.
• When Sonic is flashing press SHIFT repeatedly to select one of the five intensity levels.
• Adjust the time of your treatment for 5 to 19 minutes by pressing MODE repeatedly
until Time is selected (it will flash). Press SHIFT repeatedly to adjust the Time to the
desired treatment time.
• Press CFM to start your session.
• Lux Renew will switch off automatically after the selected treatment time is
completed. You may immediately switch it on again if you wish to continue your
session in a different treatment area.
NO
YES
Summary of Contents for LUX RENEW
Page 1: ...Instruction Manual...
