16
VIII. CTCSS Tone Setup, continued
5. Listen for the beep pattern of the 10’s digit number
you selected. This takes approximately 2 seconds.
6. Press the P-T-T bar to select the 1’s digit of the
signaling number. Each time you press the
P-T-T bar, a beep sounds and the 1’s digit of
the signaling number changes. There are a
total of 10 different numbers (0 - 9).
Action
Value Beep Pattern
Press and hold P-T-T for 2-3 seconds x 0
1-second tone
Press P-T-T 1 time
x 1
single beep
Press P-T-T 2 times
x 2
2 beeps
Press P-T-T 3 times
x 3
3 beeps
Press P-T-T 4 times
x 4
4 beeps
Press P-T-T 5 times
x 5
5 beeps
Press P-T-T 6 times
x 6
long then 1 short beep
Press P-T-T 7 times
x 7
long then 2 short beeps
Press P-T-T 8 times
x 8
long then 3 short beeps
Press P-T-T 9 times
x 9
long then 4 short beeps
NOTE: Pressing the P-T-T bar more than 9 times will
cause an error tone to sound, and no value will be
selected.
7. Listen for the beep pattern of the 1’s digit number
you selected. This takes approximately 2 seconds.
8. Press the monitor bar to complete the setting. The
LED will show green and blink twice.
9. Press the monitor bar again to confirm the beep
pattern of the selected signaling number.
Summary of Contents for MURS-22
Page 2: ...MURS 22 Operating Instructions...
Page 3: ......
