• Wrap the cord around the left side handle grip.
• Do not wrap too tightly.
FINAL ASSEMBLY INSTRUCTIONS:
PLEASE CHECK THAT YOU HAVE RECEIVED 3
CARTONS. EACH CARTON IS MARKED, AS FOL-
LOWS:
1. BASE ASSEMBLY
2. HANDLE ASSEMBLY
3. BRUSH COVER ASSEMBLY
Open all three cartons and pull out the assemblies. The
base assembly in carton 1 is encased in a clam shell foam
assembly. pull off the top foam piece exposing the base
assembly inside. Reach and grab the base assembly and
pull it out using proper lifting techniques. The assembly
is very heavy (75lbs), ask for assistance if you cannot
do it by yourself. Check for damage- report damage to
freight carrier immediately. If no damage is present, pro-
ceed to the following final assembly procedure.
Tools required:
• 5/16” Allen wrench
• Pair of adjustable wrenches or three open wrenches
(9/16”, 7/8”, and 13/16”)
ASSEMBLY OF THE BRUSH COVER TO MOTOR
ASSEMBLY:
1. Place motor base assembly upside down on the floor
or on a work bench. use a towel or soft material to pre-
vent damaging the finish.
2. Pull out the brush cover from carton 3 and align the
four holes on the brush cover to the four holes on the
motor. The two plastic caps on the brush cover should
be positioned at the front of the motor.
3. Use the four screws in the bag and mount the brush
cover. Hand-tighten the screws first and then use a
wrench to tighten them firmly. Use a CROSS pattern to
tighten the bolts as shown below.
4. Flip the motor base and place it on the floor right side
up after making sure the brush cover is
firmly attached.
5
Summary of Contents for TPL-BK-17-TC
Page 8: ...7 ...
