TRUST SPACEC@M 150
11
UK
6. Using the camera
6.1
Positioning the camera
The camera can be positioned, set down or clamped to your notebook PC, for example. For clamping it to
your notebook, clamp D can be used, for example. (See Figure 1).
In case there is too much space between the camera clamp and the object the camera is clamped to, a
rubber strip is provided to take up this space. For attaching this rubber strip, proceed as follows:
1. Clean the area to which the rubber strip will be attached and make sure it is free of grease.
2. Remove the white protective layer from the rubber strip.
3. Position the strip with the arrow, as shown in Figure 16.
Figure 16: Attaching the rubber strip
4. Press hard on the strip and attach the camera to the selected object.
6.2
Trust SpaceC@m 150 Software
During installation of the camera, the ‘Trust SpaceC@m 150’ program has been installed. Follow the
directions below to use this program.
1. Go to ‘Start - Programs - Trust - SpaceC@m 150’ and click on ‘Trust SpaceC@m 150’. Figure 17 will
appear.
Figure 17: SpaceC@M 150 software