Trust SECURITY PLUS-LINE ALSIR-2000, User Manual

Page: 8 / 102

ALSIR-2000 SIREN
2
6. Disarm ALSIR
To disarm the Siren press hold the OFF button for 4 sec on the ALKCT-2000.
If the Siren is disarmed successfully the LED on the ALKCT will light up for 1.5 seconds.
7. Tamper switch
The Siren contains a tamper switch. This is a switch that prevents the Siren from being moved when
it is armed. The tamper switch is pressed when the Siren is mounted on a wall or placed on another
flat surface. When the Siren is moved and it is armed the tamper switch will activate the alarm
immediately.
8. ALSIR placement
When placing the Siren on a wall keep attention that the tamper switch isn’t placed on a groove or
crack in the wall. Make sure that the tamper switch is placed on a location of the wall where it is firmly
pressed
9. Mount the ALSIR
To mount the Siren slide the cap off (see step 1) and screw the casing with screws on a flat surface
according to the screwholes. (Screws are included). Keep attention that the tamper switch is pressed
to the surface after mounting the Siren.
10. Close the ALSIR
Place the batteries in the Siren (see step 1) and slide the cap back on. Screw the screws back in
to secure the cap. When the Siren is triggered by a sensor it will flash and sound the alarm for
approximately 4 minutes.
11. Delete all paired devices
To delete all the devices that are paired with the Siren press the Siren learn button for 2 seconds untill
the LED is blinking. Release the button and press the button for another 6 seconds. The LED will begin
to flash quickly. Release the learn button and press it again for 1 sec to delete all paired devices.
EN