Trust ACM-3000H2, User Manual

Page: 11 / 104

3
ACM-3000H2 BUILT-IN SWITCH
9.3 Pairing confi rmation
The LED on the module will blink 2x in order to confi rm that the code is stored. Repeat steps 9.1 to 9.3
for the second lamp with the other pairing button. The receiver can store up to 6 diff erent transmitter
codes in its memory per channel. The memory is retained when the receiver is installed elsewhere or
when there is a power failure.
10. Placing the receiver
Place the receiver in the ceiling box. Mount the lights back in place or use a cover.
Make sure that you can always reach the receiver, for example, to reset it, or to register a new
transmitter.
Make sure no stripped parts of wires touch each other.
11. Wireless control
Send with the transmitter an ON signal to turn the light on wirelessly.
Send with the transmitter an OFF signal to turn the light off wirelessly.
Consult the manual of the transmitter for more information.
The existing wall switches which are used to control the connected lighting can still be used.
Deleting a single transmitter code
(a) Press for about 1 second on the Connect button. The ‘pairing mode’ will be active for 15 seconds
and the LED indicator on the receiver will fl ash slowly.
(b) Send while the ‘pairing mode’ is active with the connected Trust Smart Home transmitter an
OFF signal. If necessary, consult the instruction manual of the transmitter.
(c) The LED on the module will fl ash 2x to confi rm that the code has been removed.
Repeat this procedure to delete several transmitters from the receiver.
EN