TRUST 450I RJ45 (A)DSL MODEM & ROUTER
8
Configure PC and modem/router
Notice:
When using an Apple Mac computer make sure the network TCP/IP
settings are set to DHCP and all proxy servers are switched off,
otherwise you cannot use the modem/router.
Tip:
When using an Apple Mac the web-based menu will be the same as
when using a PC.
When the modem/router is connected as described in the quick installation guide
then the modem/router has to be configured for your (A)DSL Internet connection to
connect to the Internet. Before the modem/router can be configured the Windows
network settings first have to be set correctly. After configuring the PC as described
in the quick installation guide you configure the modem/router by entering the web-
based menu from the modem/router with you Internet Explorer.
To do this all follow the step-by-step instructions in the quick installation guide
starting at step 7 to configure your Windows network settings and Trust 450I RJ45
(A)DSL MODEM & ROUTER.
Tip:
After you have configured the (A)DSL modem/router with your
computer for Internet use you can also connect your Sony Playstation
2 or MS XBox game console for online gaming. For setting up on one
of the two game consoles consult its user’s manual.
9
Checking after installation/configuration
9.1
Hardware check
If all is connected, configured and switched on properly as specified in the quick
installation guide then the indicators should display the same status as shown in
below table 2.
Indicator: Figure:
Status:
Check:
POWER
(A, figure 1)
Lit continuously
If off then check power
adapter is connected and
check if the modem/router is
switched on. See the quick
installation guide for
instructions.
READY
(B, figure 1)
Lit continuously
If off wait for 2 minutes then
reset the modem/router.
(A)DSL
sync
(C, figure 1)
Lit continuously
If flashing continuously
check (A)DSL line
connection or wrong type/not
activated (contact Internet
service provider).
LINK
(F, figure 1)
Lit continuously
If not lit then check network
cable is connected to
computer and computer is
switched on. See QIG.
Table 2: check indicators
9.2
Check main status
You can use the web-based menu for checking your Internet connection.
1.
Open your Internet Explorer.
2.
Type “ 10.0.0.2 “ in the address bar and then press Enter on your keyboard.
3.
A Login window will appear. Enter the username “admin” and the password
“epicrouter”.
4