background image

 TRUST WIRELESS ALARM SWITCH 200DS

1

1 Introduction

This manual is intended for users of the Trust Wireless Alarm Switch 200DS. The
Wireless Alarm Switch 200DS can be used with Trust alarm systems from the 200
series.
With this wireless magnetic contact you can secure windows and doors. As soon as
contact is broken, i.e. when a window or door is being opened, the magnetic contact
will transmit a signal to the alarm centre. The magnetic contact is also provided with a
panic button in order to activate the alarm in case of emergency.
The magnetic contact is protected against sabotage and is sold with a 9V alkaline
battery

2 Safety

2.1 General

1. 

Do not use this device in damp environments such as bathrooms, swimming
pools, etc.

2. 

Do not try to repair this device yourself.

3. 

Under the following circumstances disconnect the batteries and have the
device repaired by qualified personnel:
a) 

Fluid has entered the device;

b) 

The device has been dropped and/or the housing is damaged.

2.2 Batteries

1. 

The magnetic contact’s alkaline battery is not rechargeable. Do not try to
recharge these batteries. This may result in an explosion.

2. 

Do not throw the batteries in an open fire. The batteries may explode.

3. 

Never drill a hole in the batteries.

4. 

Keep the batteries out of the reach of small children.

5. 

When the batteries are empty, ask your local authority where you can dispose
of them.

Summary of Contents for 200DS

Page 1: ... is sold with a 9V alkaline battery 2 Safety 2 1 General 1 Do not use this device in damp environments such as bathrooms swimming pools etc 2 Do not try to repair this device yourself 3 Under the following circumstances disconnect the batteries and have the device repaired by qualified personnel a Fluid has entered the device b The device has been dropped and or the housing is damaged 2 2 Batterie...

Page 2: ...e manual of your alarm system for possible settings 4 Install the magnetic contact on the door frame or window frame with the enclosed screws D E see figure 3 5 Remove the cover of the magnetic block with a small screwdriver by lifting the edge of the cover 6 Install the magnetic block F on the door or the window as close to the magnetic contact as possible with the enclosed screws see figure 3 an...

Page 3: ...ks properly 3 Set the alarm centre to the test mode press your security code 4 numbers 8 on your keyboard 4 Interrupt the magnetic contact by opening the door or the window If the alarm centre beeps and the associated zone LED goes on the magnetic contact works properly 5 Press your your security code 4 numbers 8 again to switch off the test mode of the alarm centre For further information concern...

Page 4: ...u replace the battery Check the FAQ s on the Internet www trust com You can also register your product via www trust com entitling you to receive optimal warranty service support You will be automatically informed of developments of your and of other Trust products You will also have the chance to win some spectacular prizes If you still have any problems after trying these solutions please contac...

Reviews: