TRUST 1620W WIRELESS TELEVIEWER
3
U K
23
AUDIO L
Connection for the outgoing (to the TV) left-hand AUDIO
signal (white).
24
CHANNEL
indicator
The LED indicator is lit when the receiver is switched on.
Table 2: Receiver (Rx) functions
4 Connections
Follow the instructions below to install the TRUST 1620W WIRELESS
TELEVIEWER (also see figure 2).
4.1
Connecting the receiver
1.
Turn off your computer, monitor and TV set.
2.
Disconnect your monitor’s VGA plug (
A
) from the computer.
3.
Connect the VGA daisychain plug (
B
) of the VGA cable to the VGA
connection on your computer.
4.
Connect your monitor’s VGA plug (
A
) to the VGA daisychain plug (
B
).
5.
Connect the other end of the VGA cable (
C
) to the VGA connection on the
TRUST 1620W WIRELESS TELEVIEWER.
Note:
If you connect the 1620W Wireless Televiewer to a Mac, you will
need to use VGA converter plugs for the VGA connection on
your computer and monitor.
6.
Connect the sound cable’s 3.5 mm audio jack (
D
) to the speaker output on
your sound card or to another audio source, such as the headset output of
your DVD player.
7.
Connect the power adapter to the DC-IN connection.
If desired, a TV can also be connected to the transmitter using the SCART plug.
There are two possibilities:
•
S-VHS
(black 4-pin plug): For the best image quality, connect the plug
(
E
) of the S-VHS cable to the S-VIDEO OUT connection on the
Televiewer. Connect the other end (
F
) to your TV.
•
Composite video
(yellow cinch plug): Connect the plug (
G
) of the
composite video cable to the VIDEO OUT connection on the
Televiewer. Connect the other end (
H
) to your TV.
Note:
Only the video signal will be transmitted. The AUDIO signal can
be received by using an AUDIO splitter plug (not provided) on
the AUDIO IN connection. You can plug the 3.5 mm audio jack
(
D
) in one end and a 3.5 mm audio jack with cable (not
provided) in the other, which then goes to the AUDIO IN
connection on your TV.