Metal, wood or plastic can be drilled with
the tool using drill / accessory bit three
jaws chuck with an SDS adapter (NOT INCLUDED).
• To install the three jaws chuck, go as with any other SDS accessory
(page 7, drill / accessory Installation).
• Set the bit into the three jaws chuck until is stops and secure with
the chuck key tightening each one of the orifices alternatively.
Never use the three jaws chuck with the selector
in the operation mode in the IMPACT positions ( , , ).
8
Start Up
•SDS accessories need freedom of movement inside the chuck.
This causes eccentricity when the tool is unloaded. However,
the accessory gets centered automatically during the operation
with no affectation the drilling precision.
• When the tool is new it requires 5 hours working to gain its
maximum efficiency.
• When using the tool in the drill or hammer drill mode first, set
the bit tip in the point where the orifice will be bored and then
press the switch.
The tool is built with an overload breaker that stops
the axis force (causing a rattling sound) if the
accessory gets stuck. If this happens:
• Turn off the tool immediately.
• Remove the stuck accessory.
• Turn On the tool.
Additional Information
Overload Brake
Drill with no impact
Use of the Dust Guard
Changing the Operation Mode
• Press the blocking button (
E
) and turn the function selector (
F
)
into one of the 4 positions depending on the work to carry out
until hearing a click. Assure the selector is properly secured.
Never change the function selector position
when the hammer drill motor is running.
Drill
Hammer Drill
Free mode
adjustable angle can turn
the chisel in any position
Chiseling
F
E
WARNING
WARNING
• Slide the dust guard over the bit before boring vertically
over the head. The dust guard will prevent dust from
falling over the tool and the operator when drilling
ENGLISH
Summary of Contents for ROEL-30N
Page 10: ...Notas 10 ESPA OL...
Page 22: ...Notes 10 ENGLISH...