Truper 13449, Manual

Page: 8 / 24

8
• Keep the vent slots of the motor cover clean and without
obstructions.
• After each use, use compressed air.
• If the tool is defective go only to a
Authorized Service center.
• Replace worn carbon brushes (burnt, broken or smaller
that 0.19” long). Use new carbons.
• When replacing, both carbon brushes shall be replaced
together.
• Remove worn carbon brushes from the carbon housing.
Remove accumulated dust with compressed air.
• Set the new carbons reversing the order. Carbons shall fit
easily in the carbon housing.
• After setting the new carbon brushes, let the tool run
unloaded 10 minutes to better adjust the carbons.
• Use only original spare carbons
specifically designed with the hardness and resistance
adequate for each type of motor. Carbons that are out of
specification could damage the motor.
Cleaning and care
Carbon brush replacement
ENGLISH
Maintenance