Trumpf BendMaster 150, Operator'S Manual

Page: 169 / 258

Fig. 54369
Note
There may be several search results. Image [1/2] means that
the first of the two permissible search results is displayed.
8. Press << and >> to switch back and forth between the per-
missible results.
9. Press Selection in the correct search result. The selected
search result is used as a loading stack. The "Stack layout"
mask appears.
Rough detection may be carried out both in a defined search
area and in the complete search area.
For a rough recognition in a search area, the blank may protrude
beyond the displayed search area in the X direction
(see "Fig.
39926", pg. 4
‐
73) .
10. Press Search area .
11. Enter the approximate stack height ±50 mm (stack height
only, without transport medium).
12. Press OK .
13. Drag the blue rectangle over the desired search area.
The defined search area may exceed the area covered by
the camera in the X direction:
B579EN
2015-06-01 Running in a TruTops program
4
‐
75
Rough recognition in the
defined search area