Note
(for optional store connection)
The BendMaster will stop at once if it is not in parking position
when the lift gate is opened.
All EMERGENCY STOPs released
:
■
At TruBend (control system and control panel).
■
On the portable manual control unit.
■
On the support for the portable manual control unit.
■
On all posts of the safety fencing.
At the TruBend
:
■
CONTROL key switch is set to ON.
■
Press beam not in sloping position.
■
Rear protective cover is closed.
BendMaster
:
■
Automatic operating mode is set.
■
All doors of the safety fencing are closed.
■
All lift gates are closed.
■
The GREEN button on the mounting device of the portable
manual control unit has been pressed once (BendMaster is
ready for operation).
Notes
■
Lift gates can be opened only when the safety doors are
released.
■
If the RED button flashes rapidly, this means that not all
doors of the safety fencing are closed.
■
With store connection option
: The BendMaster stops
immediately if it is not in the parking position when the lift
gate is opened.
■
With handling equipment option
: No impermissible inter-
ruption of the palletizer's protected field.
Tip
Press the GREEN button twice if the BendMaster is in the park-
ing position.
4
‐
18
Operating the BendMaster
2015-06-01
B579EN
Enabling conditions for
automatic mode
Summary of Contents for BendMaster 150
