25
Disconnect
Program Enable
.
Programming
Caution:
If the optional relay output and/or analog output board(s) are installed in
the DPM, then entering Program mode will cause both relays to release and the analog
output to go to its minimum value (0V or 4 mA) regardless of the input signal value.
To program the base unit and the option boards, follow the instructions below.
1
1
2
PGM
2
+
Connect
Program Enable
to 0V.
Use the
,
and
buttons to select a
parameter from the parameter list (see page 26).
The PGM lamp will light.
Release the buttons to see the parameter value.
Press
to see the parameter name.
Note:
The parameters for each option board will only
appear if that option board is installed.
PGM
PGM
PGM
4
+
3
Set the display back to
to try out the new
settings.
Go back to 2 to change other parameters.
Use the
,
and
buttons to edit the
parameter, as shown on page 29.
PGM
+
5
1
2
Note:
To set all parameters to their default values:
1 second
Summary of Contents for 877 Series
Page 28: ...28 Your Settings...
