Truen NCAM-531BIR, User Manual

Page: 22 / 44

NCAM-531BIR User Manual
1.3 Megapixel IP Camera Manual
22/44
Encode
Enable Preview
1. Select ON to enable to display video on the monitor that is connected to the composite or HD-SDI
video port.
2. Select the Output format accordingly in the end of the Video page.
Note that when Enable Preview is ON , dual streaming is not available.
When the video is transmitted directly to the monitor through BNC cable, the video does not go thorough
network and encoding. Therefore, there is less delay and no an effect from network limitation .
Resolution
Select video encoding resolution.
13 steps of the resolution are available.
Scaling option is used when encoding resolution is different from input compression. Without Scaling
option, input video will be cut according to encoding resolution. On the other hand, if Scaling is selected,
input video will be adjusted according to encoding resolution.
Frame rate
Determine the maximum number of frames per second for the video stream.
1,2,3,4,5,6,8,10,15,20,25 and 30 frame rate can be selected. The actual frame rate of video can be less
than the maximum frame rate set due to the network bandwidth limitation
Preference
Select encoding mode to control video quality: Quality or Bit rate.
If ‘Bit rate’ selected, the video encoding will be effected by the ‘Bit rate’ value entered. Therefore, “Bit
rate” mode is CBR (Constant Bit rate) encoding.
If ‘Quality’ selected, the video encoding will be effected by the quality of image selected. Therefore,
“Quality” mode is VBR (Variable Bit Rate) encoding.