4
INSTRUCTIONS FOR USE
Before the first use, remove all packaging material.
If the water flosser has been stored in a low temperature environment during trans-
port, leave it at room temperature for at least two hours before use.
1. Attach the head to the water flosser. You will hear a clicking sound when it is co-
rrectly attached.
2. Remove the water tank cap and fill the tank with water; the temperature of the
water should not exceed 40 °C. The capacity of the water tank is 300 ml. Then
replace the cap, ensuring that water does not spill.
3. Press the „mode change“ button and select the desired flossing mode. The mode
you have just selected will be shown on the display. You can also change the mode
while flossing. You can choose between 4 modes:
Soft mode
– suitable for people with sensitive teeth and for people star-
ting out with oral shower. Pressure range: 20–51 PSI
Medium mode
– suitable for everyday brushing. Pressure range:
50–80 PSI
Strong mode
– suitable for deep cleaning. Pressure range: 70–110 PSI
Pulse mode
– suitable for massaging teeth and gums. Pressure range:
70–100 PSI
DIY mode
– adjust the pressure to suit your needs. Long press the mode
change button to enter DIY mode. A scale will appear on the display
and gradually go from minimum pressure to maximum pressure. Press
the mode change button again to select the water pressure as required.
Pressure range: 8–110 PS
4. Leave your mouth slightly open to allow water to rinse from your mouth into the
sink. Press the On / Off button to start the flosser. Direct the water jet at a 90° angle
to the teeth and gums. Slowly run the stream of water around your teeth. Direct
the stream of water onto the gums and into the space between the teeth. If you
have braces, you can direct the water between the joints of the braces.
5. When you have finished flossing, switch off the device using the On / Off button.
Open the water tank cap and pour out any remaining water. Switch the device on
again with the On / Off button to drain the water from the pump. Press the On /
Off button to turn off the device and close the water tank cap.
