TRUE
SPEC SERIES®: STR, STA & STG, ROLL-IN AND ROLL-THROUGH
www
.
truemfg
.
com
7
STANDARD ACCESSORIES
DOOR CONFIGURATION:
After installing, cabinet doors can be adjusted for alignment. The hinge
on the door and hinge on the cabinet can be adjusted accordingly.
STEP 1
To remove door open at a 90˚ angle from the cabinet and lift door
up and out from the cabinet hinges carefully avoiding rainshield. Rest
the door in a safe area.
STEP 2
Remove gray plastic cover from hinge located on the cabinet. (See
image 1). Use a standard screw driver and pry out the gray cover.
This exposes the three Phillips screws anchoring the hinge to the
cabinet. (See image 2). Loosen these three screws but don’t remove
them. Adjustment can be made slightly up/down and side to side.
STEP 3
The hinge on the cabinet door can also be adjusted. Remove cover
from hinge located on the door. Pull on the cover directly out from
the door. (See image 3). This exposes the three Phillips screws
anchoring the hinge to the door. Loosen these three screws but
don’t remove them. The hinge can be moved side to side, up and
down. (See image 4).
NOTE: WHEN TIGHTENING THE HINGES TO THE
CABINET AND DOOR DO NOT APPLY PRESSURE
TO THE PHILLIPS SCREWS. CAREFULLY ANCHOR
THEM WITHOUT APPLYING EXTREME AMOUNTS
OF PRESSURE.
STEP 4
To adjust the lock latch remove two Phillips screws and the latch can
be put to the side for later reinstallation. (See image 5). The lock
base that anchors the latch can be adjusted simply by loosening the
two Phillips screws, but not removing them. Then the lock base can
be moved side to side for adjustment. (See image 6). After adjust-
ment is complete tighten the lock base and install the latch back into
place.
1
3
5
2
4
6
SETUP
