III. Specifications & How to Use:
6
To Cancel Timer:
While in timer status, press “Timer” key, the digital display shows countdown time. Then press
“+” or “-” key until the digital display reads “00” and timer display will blink for 10 seconds and then go off. The timer
is no longer active.
Hot Surface Indicator
After using any of the cooking zones, the cooktop will remain hot. Even after turning off the
entire unit, the surface of the cooktop will remain hot for some time. The display for the cooking
zones will show how an “H” to
warn the user that the surface is hot to touch. Wait until the “H” is no
longer displayed to clean the unit. You may turn the unit back on even if the “H” is displayed.
●
This appliance will get hot during use and will remain hot for a time after use.
●
Never heat empty cookware. This can damage both the cookware and the appliance.
●
Remember to turn off cooktop after use.
●
Keep unit away from a gas range or other heat source. If the surrounding temperature is too hot, the cooktop will
stop heating.
●
Make sure to wipe off water from the bottom of the pot before heating.
●
Use caution when boiling water. During the boiling process, hot water may splash out.
IV. Notes on Using your Cooktop
Power Sharing
When both burners are on, one of the two burners would not have a power level higher than level 7. Both of them
together would not be more than level 10. If only one burner is on, the heating zone can maintain its full heat setting,
but when operating both burners, their combined total is level 10, meaning that when operating the two burners at
the same time, they will self adjust levels accordingly. When you increase the power of one side, the power output of
the other side will reduce automatically (i.e. one side is at 6, the other burner automatically reduces
power to level 4, creating a total max 10 setting).
Set Timer Mode
The automatic timer settings range from 1 minute to 99 minutes. (
NOTE
: there is no “seconds” and “hours”
display, only minutes). when the unit is in the cooking mode press the “Timer” key. The “Timer” indicator light is lit
up, indicating the cooktop has entered Set Timer Mode, the digital display reads “00” and blinking. Press “+” or “-”
key to set the desired number, once the Timer is set and neither the “+” nor the “-” key is pressed for 10 seconds, the
Minute Timer begins the countdown and the timer reaches “00” the cooktop will sound “beep” and the specific
heating element will shut off automatically.