32
TRUE
glass
door
merchandisers
www
.
truemfg
.
com
Remove the lampshield to reveal the
bulb. Squeeze the sides of the lamp-
shield at the same time pulling it away
from the bulb.
The lamp holders are spring activated. Pull
the top lamp holder up and push the bulb
down at the same time. This will leave
enough clearance to remove the bulb.
1
2
GENERAL MAINTENANCE
LIGHT BULB REPLACEMENT (IDL)
INTEGRATED DOOR LIGHTING
WARNING:
When replacing a light bulb make sure power to the
unit is either turned off or unplugged.
IDL (INTEGRATED DOOR LIGHTING):
• Squeeze the plastic lampshield together and pull away from the
door (See Image 1).
• Push the bulb down while pulling the spring activated lampholder
up. This will give you enough clearance to take the bulb out
(See Image 2).
LIGHT COVER INSTALLATION FOR
GDM-10F & GDM-12F
IMPORTANT
Before installing lamp cover turn cabinet on and allow it to reach
temperature.
STEP 1
Locate rubber gasket behind lamp holder mounted to evaporator
housing. (See Image 1).
STEP 2
Fit the bottom edge of the lamp cover into the bottom groove of
the rubber gasket and rotate upwards while working the edges into
the rest of the rectangular groove. (See Images 2-3). (slide fingers
underneath top edges of rubber gasket and push rubber over the
top lip of the lamp shield).
STEP 3
Be sure lamp cover is seated properly in rubber gasket.
NOTE
If cabinet is turned off and interior allowed to warm up lamp cover
may become loose and require reinstallation. Follow directions above.
Lamp Cover
2
3
Rubber
Gasket
Lamp
Holder
1
FOR ADDITIONAL MAINTENANCE INSTRUCTION,
PLEASE VISIT THE MEDIA CENTER AT
WWW.TRUEMFG.COM
