True Value 134467, Owner'S Manual

Page: 12 / 25

12
FORWARD/REVERSE SWITCH
The forward/reverse switch (1) is
conveniently mounted in front of the trigger
switch (2) (Fig. 1). To make the drill rotate
clockwise for drilling, push the
forward/reverse switch to the right. To
make the drill rotate counter-clockwise,
push the forward/reverse switch to the left.
NOTES:
a) Never change the position of the
forward/reverse switch while the chuck is
turning.
b) There is no dead center position for the
forward/reverse switch. The tool will run
only when it is in either the full left or full
right position.
VARIABLE-SPEED TRIGGER SWITCH
This drill is equipped with a variable-speed
ON/OFF trigger switch.
1. To start drill, gently squeeze the
trigger switch (2) (Fig. 2).
NOTE: The drill will turn at its slowest
speed when the trigger switch is
depressed slightly. The drill will turn at its
fastest speed when the trigger switch is
fully depressed.
2. To stop the drill, release the trigger
switch.
NOTE: Drilling at a slow speed for an
extended period of time may cause the drill
motor to overheat. If drill gets hot, stop
drilling and allow it to cool for at least 15
minutes.
ASSEMBLY AND OPERATING
Fig. 1
Fig. 2