8
TRUE
tcr
/
tcf
www
.
truemfg
.
com
STANDARD ACCESSORIES
SHELVING INSTALLATION / OPERATION
STEP 1
- Position tray slide to align front to back (level) with rectan-
gular hole of the standard posts. Make sure tabs on the back-side of
the tray slide are facing down. Push in and slide down on both ends
so tabs are in the locked position. (See figure 1).
NOTE:
Make sure that pan slide is level front to back within the
refrigerator or freezer.
STEP 2
- Repeat procedure with remaining tray slides.
NOTE:
Figure 2 illustrates correct installation of tray slide.
SETUP
Tray Slide
1
2
Tray Slide
STARTUP
A. The compressor is ready to operate. Plug in the cooler.
B. Temperature controls are factory-set to give refrigerators
an approximate temperature of 35°F (1.7°C) and freezers
an approximate temperature of -10°F (-23.3°C). Allow unit
to function several hours, completely cooling cabinet before
changing the control setting.
Temperature Control Location and Settings.
• Temperature control type will vary upon model and age of
cabinet.
• Mechanical control or electronic control without display:
- Inside cabinet
- Behind cabinet
- Behind front or rear access grill
• Electronic control with display:
- In countertop
- In top louvered panel
- In or behind bottom louvered grill
See website for adjustments, sequence of operation, and more
information.
C. Excessive tampering with the control could lead to service
difficulties. Should it ever become necessary to replace
temperature control, be sure it is ordered from your TRUE
dealer or recommended service agent.
D. Good air flow in your TRUE unit is critical. Be careful to
load product so that it neither presses against the back wall,
nor comes within four inches of the evaporator housing.
Refrigerated air off the coil must circulate down the back wall.
NOTE:
If the unit is disconnected or shut off, wait five minutes
before starting again.
RECOMMENDATION
- Before loading product we recommend
you run your TRUE unit empty for two to three days. This allows
you to be sure electrical wiring and installation are correct and no
shipping damage has occurred. Remember, our factory warranty does
not cover product loss!
OPERATION
