8
TRUE
refrigerated
prep
www
.
truemfg
.
com
AIR-FLOW THROUGHOUT CABINET
(TPP Models Only)
WARNING:
Removal of baffles in condiment pan area will adverse-
ly affect refrigeration performance. Please leave the baffles in the
correct location. (See images)
Correct baffle location.
INSTALLING CUTTING BOARD ON MODEL TPP AND
TFP
A. Locate and remove the cutting board from the back or side of
cabinet. (see images 1 and 2)
B. Locate brackets and mounting hardware. (see image 3)
C. Place the cutting board on countertop.
D. Position one bracket on the cutting board and align hole in
bracket with pre-installed Rivnut in the side of the countertop.
E. Secure bracket to countertop with included hardware.
(see image 4)
F. Repeat install for bracket on opposite side.
2
1
3
4
LIGHT SWITCH LOCATION:
Light switch location depends upon the TUC & TWT glass door
models. Most models will have the light switch located inside the unit
above the door. Most instances the switch is located next to the light
on the ceiling.
DRAWER SET 2
REMOVAL
Slide out drawer and locate white drawer retainer.
Push white drawer retainer towards drawer front panel.
Pull up on the white drawer retainer and disengage from drawer.
Image 5.
Pull out and remove drawers.
INSTALLATION
Verify white drawer retainer is in the up position. Image 6.
Insert drawer onto drawer slide and push into position. Image 7.
Secure drawer to slide by pushing down on the white drawer retainer
and pushing back to lock. Image 8.
Verify drawer operation.
5
6
7
8
DRAWER REMOVAL & INSTALLATION
Depending on the version and model of the cabinet, one of the fol-
lowing drawer configurations will be standard.
DRAWER SET 1
REMOVAL
Open drawer completely. Roller clips will be in the down position.
Images 1 & 2.
While holding the sides of the drawer, use your finger to rotate the
clips upward. Image 3.
Lift drawer and remove from channel. Image 4.
INSTALLATION
Lower rear rollers into channel slots.
With the roller clips in the upward position, lower front rollers into
channel.
Make sure roller clips are in the down position.
1
2
3
4
