background image

Locate the desired location for the speaker to be mounted.  Check the area for obstructions such 
as plumbing, heating ducts or electrical wiring.  

Next, locate the wood studs or joists nearest the desired location.  Use the supplied speaker 
cutout to get the recommended hole dimensions.  Position the cutout in the desired location and 
outline the speaker opening.  If you are not sure of possible obstructions, cut a small hole in the 
center of your outline.  This will allow you to check for obstructions.  If there are no problems 
with your mounting location, proceed and cutout the outlined hole.  

If the wall or ceiling in not already insulated, we suggest adding insulation, Dacron or some 
other sound dampening material.  If this material has a foil layer, position the foil away from the 
speaker magnet.

Swivel Tweeters

The adjustable, swivel tweeter allows you to point the sound towards or away from the listening 
area, depending on the room design and furniture location.  If your model includes this feature, 
gently push the edge of the tweeter housing to aim the tweeter to the desired area.  Be careful not 
to damage the tweeter during this procedure.

Setting Level Controls

Tweeter Level control: Some models offers level control for tweeter volume.  You can use this 
control to get more or less high frequency.  Turn the knob to each setting until you get the 
desired amount of high frequency.  The adjustments are 3dB, 0dB and –3 dB.  

Woofer Level control:  Some models also offer level control for the bass output of your speaker.  
Like the tweeter control, you can adjust the bass volume by turning the knob to each setting until 
you get the desired sound.  The adjustments are 3dB, 0dB and –3 dB.  

If only two channels (R & L) of your amplifier are driving more than one pair of speakers, 
TRUAUDIO suggests using the lowest output position for the woofer until you can make sure 
the amplifier can handle the additional woofer settings.  

We also suggest setting your Tweeter levels first and then matching the bass output to get the 
overall sound you desire.

Summary of Contents for CP-5

Page 1: ...cations when finalizing your speaker locations If the speakers are mounted away from the listening area adjust the tweeter so it is pointing toward it Prep before Speaker Installation If you re your speakers were pre wired at construction time your dealer might have used TRUAUDIO s Rough in kits ES EL series prior to drywall at each speaker location There should also be speaker cable at this locat...

Page 2: ...ending on the room design and furniture location If your model includes this feature gently push the edge of the tweeter housing to aim the tweeter to the desired area Be careful not to damage the tweeter during this procedure Setting Level Controls Tweeter Level control Some models offers level control for tweeter volume You can use this control to get more or less high frequency Turn the knob to...

Page 3: ...aint them while they are still in the wall remove the grill and replace it with the provided paint guards Then you may proceed and paint the frame of the speakers When painting the grills paint them lightly and be careful not to clog the holes Do not paint the grill while its still on the speaker paint them separately SoundVision Technologies dba TRUAUDIO Speaker Systems P R O D U C T W A R R A N ...

Page 4: ...8 1 8 diameter CP 8 Design 2 way in ceiling Woofer 8 polypropylene Tweeter 1 silk dome swivel Power 5 100 watts Impedance 8 ohms Frequency Response 42 20K Hz Sensitivity 90 dB 1W 1M Finish Dimensions 11 1 8 diameter 3 1 4 D Cutout Dimensions 9 3 4 diameter It is the policy of TRUAUDIO to continuously incorporate improvements into our products All specifications are subject to change without notice...

Reviews: