TRUArt Pyrography Pen, User Manual, Page: 23 / 41

Copyright 2020 TRUArt LLC
23
Once you have completed the burning, you may have some marks left on your wood from where
you traced your design.
These markings cannot simply be erased with a regular eraser. Get a
magic eraser. Add only a little water to the eraser and gently rub in a circular motion evenly
across the wood. If you do not, you will have splotchy marks on your wood when you stain. If
that happens, simply sand the wood down on those areas. If the image smears with the eraser,
you may be rubbing too hard.
Gently rub the eraser on the smudges until they are gone. Let
the wood completely dry.
To give the wood a finished look, add a little stain on it. Be sure not to add too much stain or
too dark of a stain or the image will fade into the wood. To protect the image from darkening
over time, varnish the wood with polyurethane or resin.
Now, all you have to do is enjoy all your hard work. Keep practicing and be patient with
yourself. Hang in there, you will get it. I wish you the best of luck and I will see you next time on
truart.co with some more tips to help you along the way.