8
ASSEMBLING THE BLENDER
Hold the blender blade by the shaft and push onto the metal shaft in the bottom of the blender jar until secure. Align the U-shape openings
on the blender collar with the U shapes in the blender jar and push in place. Align the pins in the blender collar with the small openings in
the motor housing and place the motor housing onto the blender collar. The motor housing should fit flush with no gaps.
HOW TO USE THE BLENDER
This blender can be used just like a normal blender but without the cord!
1. Place blender blade onto metal shaft in the bottom of the blender jar.
2. Place food to be blended into the jar. Do not overfill.
3. Place the blender collar and motor housing onto the jar. The lights will flash on to indicate the unit is ready to use.
4. Press the I (low) or II (high) speed button on top of the motor housing.
5. Allow the blender to work through the blending process. Do not shake or move the blender while operating.
6. When blending has finished, release the speed button and the unit will stop.
7. Ensure the blade has completely stopped before removing the motor housing and blender collar.
8. Remove the blender blade by grasping the shaft firmly and lift up. Be careful, the blades are sharp!
9. After the blender blade has been removed the ingredients can be poured from the blender jar.
10. Do not use the blender for longer than 1 minute continuously. After 1 minute of continuous use, the unit may become over-heated.
Allow the unit to rest for at least 5 min before resuming use.
11. The lights will extinguish as the battery life reduces. A fully charged unit will show all three lights. When only the lowest light is
illuminated and flashing, this incidates that the unit needs to be charged.
If food becomes lodged around the blender blade during use:
1. Release the speed button and wait for the blades to stop.
2. Remove the motor housing and collar.
3. Use a spatula to carefully dislodge the food. Do not use fingers as the blades are sharp.
4. After the food has been removed and blades are clear, reassemble the collar and motor housing and continue use.
