PAKCROWN
Outdoor Luxury
Install Guide
3. A 21” x 20” x 19” deep hole for the ST-SUB-10, or a 27” x 24” x 25” deep hole for the ST-SUB-12 should be
4. Set all Acoustiscape speakers to 70V AS-1(30w),AS-2(50W). Wire up Acoustiscape speakers
in parallel to channel 2.
5. Wire the RCA's into the input section of the Crown amp as shown in illustration below.
Sub-Terrain
Acoustiscape
dug and prepped. When using two Subterrain’s you can wire them in parallel. Bury the Subterrain(s) and
wire to channel 1.
2. Set left and right gains evenly at 95% - 2 clicks back from full.
1. The Crown amp comes shipped at AS2/S10 preset. To change the preset press SET/ENTER twice
then use down/up button to select the right setting then press SET/ENTER button to load.
AS1/HS = AS-1 With Normal sub level
AS1/HS+ = AS-1 With sub level + 5db
AS2/HS = AS-2 With Normal sub level.
AS2/HS+ = AS-2 With sub level + 5db
BDCL/HS = AS-2 With Normal sub level.
BDCL/HS+ = AS-2 With sub level + 5db
BD/CL = BeatDrop or CL-70V
AS2/AS2 = AS2 on both channels
AS1/S10 = AS-1 With Normal sub level
AS1/S10+ = AS-1 With sub level + 5db
AS2/S10 = AS-2 With Normal sub level.
AS2/10+ = AS-2 With sub level + 5db
AS1/S12 = AS-1 With Normal sub level
AS1/S12+ = AS-1 With sub level + 5db
AS2/S12 = AS-2 With Normal sub level.
AS2/S12+ = AS-2 With sub level + 5db
Gains
WARNING
:
Amplifier must be configured
BEFORE
speaker wires are connected.
AMP CONFIGURATION
