Please follow these steps:
1. Switch OFF the TURTLE SMART
2. Connect the USB cable to the TURTLE SMART and the PC
3. Start the TURTLE loader
4. Switch ON the TURTLE SMART unit and choice the serial port in the menu No 1.
5. If the TURTLE SMART is connected properly the logo in the right side becomes inverted. (If it is not please start again the process from the first step)
6. Select the strobe model which you would like to control with your TURTLE SMART in the menu No 3.
7.The “WL” wireless mode programmed by the user. There are three special function what can be use .
1. Manual mode first curtain expo and power setup
2. Manual mode second curtain expo and power setup.
3. Manual special stroboscope function where the strobe flashing 1-10 times in one expo.
8. Press the Download button.
During the download in the configured system window there is a “downloading” sign.
After the download in the configured system window you can check which strobe setup is downloaded to the TURTLE SMART.
9. Disconnect the PC and the TURTLE SMART.
10. Switch OFF and ON the TURTLE SMART before using.
Connecting the camera and the strobe (How to use the TURTLE SMART)
To connect and use the strobes you should do these steps only once.
The TURTLE SMART can control the strobes via fiber optic cables (LED) or sync cords
1. To use fiber optic cables with LEDs : Just connect the LEDBOARD directly to the TURTLE SMART and mount the LEDs in the housing’s window. If you
need advice about mounting LEDs in a specific housing, just contact us!
2.Sync cord : It is recommended to leave it to an electrician. If you use “Y” sync cord cable you have to make
the correct wiring between the TURTLE and you bulkhead.
After proper connection you need to turn on your TURTLE SMART, attach it to your camera's hot shoe and you can start taking photographs. We recommend
to test the TTL and Manual modes in the surface or in a pool to be familiar with the trigger and to check if there is any problems.
Charging
The device can be charged only when it is turned OFF!
1. Switch off and connect the cable to 2. Wait until the device
the TURTLE SMART device,
is fully charged (red light off)
during the charging the red light is on!
Storing
If you won't use your TURTLE SMART TTL converter for a longer period, charge its battery,
and turn off the main switch.
Support
If you have any questions don’t hesitate to write us : [email protected]
We wish you great dives, and hopefully you will shoot cool pictures with your new TURTLE SMART!
www.trt-electronics.com
Maximum
charging time is
approximately 1
hour!
The battery level indicator LED is on the left
side of the back of the unit. The LED starts
blinking if the battery level is under 20%.
TURTLE
1. LED +
2. LED -
3. Gnd
4. Q-Quench
5. X-Trigger
The TURTLE does not use the SP, READY POWER, S pins.
You have to connect only 3 pins! Not more! X, Q, GND.
N5 IKELITE Sea and Sea
Warning!
It is not permitted to use 4,5,6 pins. It can lead to the damage of
the device. We do not take responsibility for these damages.
