- Connect the battery to the driver verifying the correct polarity. It is advisable to
maintain a distance with LED lamp.
-Introduce the driver and battery through the ceiling hole, and recess the luminary in the ceiling, Switch ON the
power and verify that the Green LED indicating the battery charging and 3*1W LED lamp ( in permanent mode) is
ON.
IMPORTANTE: Do not disconnect the 3*1W LED lamp from the driver in working mode.by doing so the driver will
be blocked, to unblock, disconnect the power line then the battery from the driver, wait for a few seconds and
connect the 3*1W LED lamp, then the battery and followed by the power line.
Maintenance:
The manipulation and the installation of the kit should be done by qualified technicians.
Always verify that the Voltage of the Mains is adequate to the input voltage of KIT.
Before installation make sure the mains is OFF and the battery is disconnected.
The Ni-cd battery has a life cycle of 4 years or 400 charging cycles, after this, it should be substituted and date of
substitution should be notified.
The old battery should be recycled in a proper way, as it can be harmful for the environment.
Dimensions:
Weight: 102gr. Weight: 107gr.
Connection Diagram:
NON MAINTAINED
MAINTAINED
MAINTAINED with SWITCH to switch ON/OF the LED Lamp
Telemando Connection:
