Section 3
Using TROY Fonts
Font Card Kit User’s Guide -- Document #50-70407-003 Rev. A
3-1
Introduction
Accessing
and Using
TROY Fonts
Accessing TROY
Fonts Using
Windows
Applications
Accessing TROY
Fonts Using Non-
Windows
Applications
The TROY MICR E-13B and CMC-7 MICR fonts have been specifically engineered for your TROY Security
Printing Solution to ensure the highest quality MICR printing in the industry. The TROY font collection
provides seamless integration and security within your Windows-based check printing application. All TROY
fonts are permanently programmed into the TROY Font Card to ensure consistent high-quality MICR printing
and to prevent unauthorized use of these fonts on another printing system. Your TROY Security Printing
Solution includes the following fonts:
•
TROY MICR Font (E-13B and CMC-7)
•
TROY Security Font (English and Spanish)
•
TROY Convenience Fonts (Enhanced, Large and Small)
•
TROY Reverse Helvetica Font
•
TROY OCR Fonts (type A and B)
•
British Pound and Euro symbols
•
TROY POSTNET and Barcode Fonts (not available for TROY 2300 Font DIMM Kits)
The following paragraphs provide some basic information for accessing and using the TROY fonts. It is
important that these fonts are kept secure to prevent unauthorized use and that the fonts remain unaltered to
ensure accurate rendering by your printer. All TROY fonts are permanently programmed into the TROY Font
Card and cannot be directly accessed through external means.
To access the TROY fonts in a Windows environment, you must first install the Windows printer driver for your
HP 4014, 4015, or 4515 LaserJet printer. Follow the instructions in
TROY Font Card Kit Quick-Start Guide
to
install the printer driver and Windows support files, enabling you to select these fonts from any Windows-based
application. To print the TROY E13-B and CMC-7 MICR fonts, your printer must be set to MICR enabled
mode, and a TROY MICR toner cartridge must be installed in the printer. Many commercial MICR check-
printing applications are pre-programmed to access the TROY MICR fonts.
If you are using a non-Windows application to print MICR documents, the escape sequence for each font must be
programmed into your check-printing application in order to “call” each of the selected fonts. The <Esc>
character is ASCII character number 27 (hexadecimal number 1B). Refer to the end of this section for each
escape sequence (displayed above each character map) used to call each TROY font.
