1mm
Tailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Keep some space about 1mm width between the rudder
and tail edge.
Epoxy the rudder to the vertical fin..
Assemble the tail landing gear to tail fuselage as below.
Epoxy the control horns to the slots in the rudder.
Rudder
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Make sure hinges are
mounted in the same line.
TP Screw (2.3x12mm)
42mm
25mm
3mm
Trim a slot and drill a hole in the rudder for helping
assemble the tail landing to it.
Epoxy the aileron and pivot & round hinges and the
landing gear to the rudder as illustration.
27
26
6
29
28
31
30
2
2
Clevis
Copper joiner
2
Screw (2x10mm)
2
Washer(2x5mm)
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Clevis
Washer(2x5mm)
Install the servo of the rudder.
Assemble the servo of the rudder in the fuselage and
connect the servo and the rudder via steel wires.
Lock the linkage to the control horn with screws and nuts
as below.
The sketch map of how the steel wires works for the rudder.
Nut 2mm
Screw (2x10mm)
Washer(2x5mm)
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
The sketch map should be when the rudder and stabilizer
install completion.
A = A ’
B = B ’
A
A ’
B
B ’
Accessory list for the coming installation steps.
1
Engine mount (60x5mm)
Linkage Stopper
12
4
Washer(4x8mm)
Screw (4x45mm)
2
4
Screw (4x20mm)
4
4
Plastic tube (2x400mm)
Fuel tank (550cc)
1
1
Cable tie
2
Rod (2x200mm)
Blind Nut (5mm)
Steel wire
Copper joiner
Aluminum tube
Clevis
33
34
35
32
36
7
