Troy-Bilt Wide-Cut 753B, Operator'S Manual

Page: 8 / 40

Section 2: Assembly
3. Add a 5/16" washer (A, Figure 2-6)
and secure with a hairpin clip (B).
4. At upper end of control rod, re-insert
the angled end into the Wheel Drive
Control lever (V, Figure 2-6A) and re-
attach with hairpin clip (BB) removed
earlier.
B. Attach Operator Presence Control
Rod
1. Locate the Operator Presence Control
rod (E, Figures. 2-6 and 2-7) . At bottom
of control rod, insert swivel block (G,
Figures 2-6 & 2-7) into control arm (T,
Figure 2-6).
2. Add one 5/16" washer and secure
with hairpin clip.
C. Attach Blade Drive Control Rod
1. Locate the blade drive control rod (C,
Figure 2-7). Insert one end of control rod
into blade drive bracket (D, Figure 2-7).
Add one 5/16" washer and attach with
hairpin clip (CC).
2. Insert the other end of rod into bot-
tom end of Blade Drive Control lever (J,
Figure 2-7). Add one 5/16" washer and
attach with hairpin clip (AA).
D. Attach and Adjust Gear Select Lever
NOTE: The retaining plate (N, Figure 2-7)
mentioned in the following steps is se-
cured to the rear of the mower with two
screws (O, Figure 2-7) and 1/4”-20 lock-
nuts. Remove the retaining plate and
save it, along with the two screws, be-
fore proceeding with assembly.
1. Remove the vinyl grip (B, Figure 2-8)
from the gear select lever (I). Place the
wood edge against the edge of the grip
and slowly pull off the grip.
Figure 2-6A: Attach wheel drive control rod
to lever.
V
F
BB
Figure 2-7: Rear view of control rods.
G N
P O
H
F
E
I
C
J
AA
CC
D
L
M
V
W
Figure 2-8: Detail – Gear Select Lever in Neutral (N) position.
I
L
K
P
B
Z
Pin (K) must be in this detent
when transmission neutral is
adjusted.
J
6