![background image](http://html1.mh-extra.com/html/troy-bilt/tb525et/tb525et_operators-manual_1173560012.webp)
12
6.
Pull the line from the outer spool until the line is tight
against the inner reel (Fig. 24).
7.
Repeat procedures 4-6 with the second piece of line.
8.
Hold the outer spool. Wind the inner reel counterclockwise
until approximately four (4) inches (102 mm) of line remain
(Fig. 25).
NOTE:
Do not wind the inner reel before installing the second
piece of line.
9.
If winding the line becomes difficult or if the line jams, pull
the ends of the line from the spool (Fig. 26). Continue
winding the inner reel counterclockwise.
INSTALLING A PRE-WOUND REEL
1.
Turn the bump knob counterclockwise and remove the
bump knob, spring and foam seal (Fig. 27).
MAINTENANCE AND REPAIR INSTRUCTIONS
2.
Pull the old inner reel with existing line from the outer
spool.
3.
Insert the ends of the prewound inner reel line into the
outer spool eyelets (Fig. 28). Push the new inner reel,
arrow side up, into the outer spool.
4.
Hold the inner reel in place and install the bump knob,
spring and foam seal. Press down and turn the bump
knob clockwise. Grasp the ends and pull firmly to release
the line from the holding slots in the inner reel (Fig. 26).
RELEASING THE INNER REEL
If the SpeedSpool® does not release line correctly, pull the
ends of the line firmly from the spool (Fig. 26). If this does not
the release line, follow the
Cleaning the SpeedSpool
®
instructions.
CLEANING THE SPEEDSPOOL®
Cleaning the SpeedSpool
®
may be necessary if:
• A jammed or excessive line must be removed
• The SpeedSpool® becomes difficult to wind or does not
operate correctly when bumping the head on the ground
1.
Hold the outer spool, and unscrew the bump knob
counterclockwise (Fig. 29).
2.
Pull out the bump knob, spring and foam seal (Fig. 27).
3.
Pull the inner reel with existing line from the outer spool.
4.
Remove any existing line from the inner reel before
cleaning. Remove any debris or grass from the knob,
spring, inner reel and foam seal. Wash the inner reel with
warm soapy water (Fig. 30).
Bump Knob
Foam Seal
Spring
Inner Reel
Inner Reel
Fig. 24
Fig. 25
Fig. 26
Fig. 27
Fig. 28
Fig. 29
Fig. 30
Summary of Contents for TB525ET
Page 64: ...NOTES...
Page 65: ...NOTES...