![background image](http://html1.mh-extra.com/html/troy-bilt/tb32cs/tb32cs_operators-manual_1173536007.webp)
7
On some units, the D-handle may be pre-installed. In
this case you must loosen the wing nut and adjust the
handle to fit the operator. Go to step 4 if the D-handle is
pre-installed.
INSTALLING AND ADJUSTING THE D-HANDLE
1. Remove the bolt, wing but and washer that were
installed on the D-handle for shipping.
2. Place D-handle the over the shaft housing and push
it on the boom (Fig. 1).
Fig. 1
Fig. 2
ASSEMBLY INSTRUCTIONS
3, Install the bolt, washer and wing nut. Tighten them.
4. If the D-handle was pre-installed, loosen the wing nut
just enough so it is movable.
5. While holding the unit in the operating position,
arrange or rotate the D-handle to the location that
provides you the best grip (Fig. 2).
6. Tighten the wing nut until the D-handle is secure.
INSTALLING THE CUTTING SHIELD
Use the following instructions if the cutting attachment
shield on your unit is not installed or if you ever need to
re-install it.
1. Place the cutting attachment shield onto the shaft
housing above the clamp assembly (Fig. 3).
2. Push the cutting attachment shield down to the top
of the cutting attachment assembly. Then rotate the
shield until its screw holes line up with the holes in
the cutting attachment. The shield guard should fit
into the recessed pocket (Fig. 4).
3. Install the screws with a Phillips screwdriver (Fig. 5).
WARNING: Never operate the trimmer
without the cutting attachment shield in place
to prevent serious personal injury.
Fig. 3
Fig. 4
Shaft Housing
Cutting Attachment
Shield
Cutting Attachment
Fig. 5
(4) Screws
Clamp
Cutting Attachment
Shield
Summary of Contents for TB32CS
Page 48: ...E16 NOTAS...
Page 49: ...E17 NOTAS...