![background image](http://html1.mh-extra.com/html/troy-bilt/tb-1942-hydro/tb-1942-hydro_operators-manual_1173102009.webp)
Assembly & Set-Up
3
9
NOTE:
This Operator’s Manual covers several models. Tractor
features may vary by model. Not all features in this manual are
applicable to all tractor models and the tractor depicted may
differ from yours.
NOTE:
All references in this manual to the left or right side and
front or back of the tractor are from the operating position only.
Exceptions, if any, will be specified.
Tractor Preparation
Manually Moving the Tractor
1. Engage the transmission bypass rod to move the tractor
manually without starting it. The transmission bypass rod is
located on the rear of the tractor, on the frame. Engage the
bypass rod by pulling out. See Figure 3-1.
Figure 3-1
NOTE:
If the tractor will not move or does not move freely
when pushing check if the bypass lever is fully open or the
brake is engaged.
NOTE:
The transmission will NOT engage when the
hydrostatic bypass rod is pulled out. Return the rod to its
normal position prior to operating the tractor. If the tractor
will not move when pushing on the forward/reverse pedals,
or moves slowly, check to see of the bypass valve is on.
CAUTION:
Never tow your tractor. Towing the
tractor with the rear wheels on the ground may
cause severe damage to the transmissions.
2. Disengage the bypass rod by pushing the rod back in after
moving the tractor. See Figure 3-1.
Contents of Crate
•
One Tractor
•
One Operator’s Manual
•
One Engine Operator’s Manual
Install Operator’s Seat (If necessary)
WARNING!
Before operating the tractor, make
sure the seat is engaged in the seat-stop. Engage the
parking brake. Stand behind the machine and pull
back on seat until it clicks into place.
To install the seat proceed as follows:
NOTE:
The seat is shipped with the seat switch and seat
pan attached.
1.
Cut any straps securing the seat assembly to the tractor.
Remove any packing material.
NOTE:
Be careful not to cut the wiring harness connecting
the seat and the seat switch.
2.
Remove the two shoulder screws, flange bearings and
flange lock nuts in the seat pan as shown in Figure 3-2.
Figure 3-2
NOTE:
Be sure that the nylon flange bearings (if equipped)
remain in place on the seat bracket mounting holes. If
they come out during the removal of the shoulders screws
and flange lock nuts make sure to replace them before
installing the seat.