![background image](http://html.mh-extra.com/html/troy-bilt/polar-blast-10530/polar-blast-10530_operators-manual_1173271008.webp)
8
Figure 8
Auger Control
The auger control is located on the left handle.
Squeeze the auger control to engage the augers.
Release to stop the snow throwing action. The drive
control must also be released in order to stop the auger.
IMPORTANT:
Refer to
Auger Control Test
on page 10 prior
to operating your snow thrower. Read and follow all
instructions carefully and perform all adjustments to
verify your snow thrower is operating safely and
properly.
Chute Tilt Control
The distance snow is thrown can be changed by
adjusting the angle of the upper chute. Move the chute
tilt control forward to decrease the distance, and
backwards to increase distance. See Figure 8.
Chute Directional Control
The chute directional control is located on left hand side
of the snow thrower.To change the direction which
snow is thrown, rotate chute directional control as
follows:
•
Clockwise to discharge to the left.
•
Counterclockwise to discharge to the right.
Headlights
When properly connected, both headlights illuminate
whenever the engine is running.
Clean-out Tool
WARNING:
Never use your hand to clear a
clogged chute. Shut off engine and remain
behind handles until all moving parts have
stopped before unclogging. Use the clean-out
tool or a stick to unclog.
This item, along with the electric cord, is fastened with a
cable tie to the rear of the auger housing at the factory.
Cut the cable tie and remove the electric cord before
operating the snow thrower.
The clean-out tool (see Figure 8) is designed to clear a
clogged chute. Refer to page 11 for detailed
instructions on how to properly use the clean-out tool.
Wheel Steering Controls
The left and right wheel steering controls are located on
the underside of the handles and are used to assist in
steering the snow thrower.
•
Squeeze the right wheel steering control when
turning right; squeeze the left control when turning
left.
•
Operate the snow thrower in open areas until
becoming familiar with these controls.
Switch
Box
Electric
Starter
Button
Recoil
Starter
Handle
Primer
Choke
Throttle Control
Open
Fuel Tank
Auger
Skid Shoe
Shift Lever
Drive Control /
Headlights
Discharge
Auger Control
Left Wheel Steering Control
Chute Tilt Control
Auger Control Lock
Chute
Chute
Clean-out Tool
Chute
Directional Control
Safety Ignition
Key
Closed
Fuel Shut-Off Valve
*If Equipped
Right Wheel Steering Control
Summary of Contents for Polar Blast 10530
Page 29: ...29 NOTES ...
Page 30: ...30 NOTES ...