C.
Place the Tines/PTO Lever in the
DISENGAGED position. See Photo 3.
D.
Using a long
3
/
4
" wrench, loosen, but do not
remove, the two swing-bolts which connect the
transmissions of the Power Unit and the Tine
Attachment Unit, until you can swing the bolts
outward. See Photo 4.
E.
With one hand on the handlebars, tip the
Power Unit forward about one inch while pulling
back on the Tine Attachment with your other
hand. This releases the Power Unit alignment
pin from the alignment hole on the Tine
Attachment. Refer to Photo 5.
F.
Remove the Tine Attachment and set it aside.
G.
Because so many PTO Horse Model Tiller
owners use their power units with other T
roy
-
B
ilt
attachments,
Troy-Bilt
has designed a
Tine Cradle which is a convenient accessory for
storing the Tine Attachment in a level position.
This prevents transmission gear oil leakage and
also assists in the removal and replacement of
the Tine Attachment. Refer to Photo 6 below
showing the Tine Attachment in place on the
Tine Cradle. To order a Tine Cradle for your
Horse Model Tiller, order Part No. GW-12583.
2
Photo 2: Place a block or box under the engine.
Photo 6: Tine Attachment stored on Tine Cradle.
Photo 5: Remove the Tine Attachment.
Photo 3: Tines/PTO Lever in DISENGAGED position.
Photo 4: Move the swing-bolts outward.