![background image](http://html.mh-extra.com/html/troy-bilt/horse-z809k/horse-z809k_operators-manual_1173003022.webp)
22
IMPORTANT:
Note the routing of the lower drive belt
around both the pulleys and the belt keepers before
performing the following steps.
•
Locate the variable-speed pulley through the
battery tray opening. See Figure 17.
•
Remove the variable-speed pulley by loosening the
hex bolt that secures it to the transmission. Use a
second wrench to hold the hex nut on the bottom
side of the pulley.
•
Slide the belt off the variable-speed pulley as you
lift the pulley up and out through the battery tray
opening.
•
Remove rear idler pulley from the double- idler
bracket while loosening the belt from around both
the rear and the front idler pulleys. See Figure 17.
•
Remove the hex bolt from the center of the electric
PTO clutch and gently lower it off the engine
crankshaft. Be careful not to lose any washers or
which may be found on top of the PTO clutch.
IMPORTANT:
When remounting the PTO clutch, torque
the center hex bolt to between 38 foot-pounds and 50
foot-pounds.
•
Remove the drive belt by feeding it from both ends
toward the front idler pulley on the double-idler
bracket. See Figure 18.
Figure 18
•
Reassemble by following the above steps in
reverse order.
•
Reroute the new belt around the pulleys, belt
keepers and keeper pins exactly as the old one was
routed. Refer to Figure 17.
The drive pedal is properly adjusted when the hole
found in the double-idler bracket has approximately
1-3/8" of travel with ten pounds of pressure applied to
the drive pedal. See Figure 19.
Figure 19
Adjust the drive pedal after replacing the drive belts on
your tractor, if necessary, as follows:
•
Locate the speed control assembly on the
underside of the steering support bracket. See
Figure 18.
•
Remove both hairpin clips from the pin which is
fastened to the speed control assembly (be careful
not to lose the small flat washers found on the pin).
See Figure 18.
•
Remove the drive pedal return spring.
•
Using two 9/16" wrenches, remove the pin from the
speed control assembly. See Figure 18.
•
Thread the idler adjustment rod inward or outward
to lengthen or shorten the travel of the double-idler
bracket until proper adjustment is achieved.
•
Reassemble by following the above steps in
reverse order.
Tires
Refer to the tire sidewall for exact tire manufacturer’s
recommended or maximum psi. Do not overinflate.
Uneven tire pressure could cause the cutting deck to
mow unevenly.
Cutting Blades
•
Periodically inspect the blade adapter and/or
spindle for cracks or damage, especially if you
strike a foreign object. Replace immediately if
damaged
.
Speed Control
Assembly
Hairpin
Clips
Idler Adj. Rod
Pin
Drive Pedal
Return Spring
Place Wrenches Here
Neutral
Return
Bracket
WARNING:
Never exceed the maximum
inflation pressure shown on the tire sidewall.
WARNING:
Be sure to shut the engine off,
remove ignition key, disconnect the spark plug
wire(s) and ground against the engine to
prevent unintended starting before removing
the cutting blade(s) for sharpening or
replacement. Protect your hands by using
heavy gloves or a rag to grasp the cutting
blade.
Front of Tractor
NOTE:
View shown from above tractor.
Double-idler Bracket
Idler
Adjuster Rod
Hole
1-3/8
”