![background image](http://html1.mh-extra.com/html/troy-bilt/8000-watt/8000-watt_operators-manual_1173156007.webp)
7
Assembly
Read entire operator’s manual before you attempt
to assemble or operate your new generator.
Your generator requires some assembly and is ready for use
after it has been properly serviced with the recommended
fuel and oil level is verified.
If you have any problems with the assembly of your
generator, please call the generator helpline at
(888) 611-6708
. If calling for assistance, please have the
model, revision, and serial number from the data tag
available. See
Features and Controls
for data tag location.
Unpack Generator
1. Set the carton on a rigid, flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.
Shipment Contents
The generator is supplied with:
• Engine oil bottles
• Operator’s manual
• Battery float charger
• Wheel kit
• Adapter cord set
Install Wheel Kit
NOTE:
Wheel kit is not intended for over-the-road use.
You will need the following tools to install these components:
• 13 mm wrench
• Socket wrench with a 13 mm socket
• Pliers
• Safety glasses
Install the wheel kit as follows:
1. Tip generator so that engine end is up.
2. Slide axle (
A
) through both mounting brackets.
3. Slide a wheel (
B
) over axle.
NOTE:
Be sure to install both wheels with the air pressure
valve on the outboard side.
4. Place a washer (
C
) on axle and then place an e-ring (
D
)
in axle groove.
5. Install e-ring with pliers, squeezing from top of e-ring
to bottom of axle.
6. Repeat steps 3 through 5 to secure second wheel.
7. Tip generator so that engine side is down.
8. Line up holes in support leg (
E
) with holes in generator
frame.
9. Attach support leg using 2 capscrews (M8 x 20 mm)
(
F
) and 2 hex nuts (
G
). Tighten with a 13 mm socket
wrench and 13 mm wrench.
10. Return generator to normal operating position (resting
on wheels and support leg).
11. Loop handle pins (
H
) to generator frame as shown.
Raise handles and insert handle pins to move generator.
12. Check each fastener to ensure it is secure and the tires
are inflated between 15-40 PSI.
A
B
C
D
F
G
E
H
CAUTION
E-rings can cause eye injury.
E-rings can spring back and become airborne
when installing or removing.
• Always wear eye protection when installing/removing e-rings.
Summary of Contents for 8000 Watt
Page 3: ...3 Espa ol Table of Contents...
Page 25: ...25...
Page 29: ...3 Espa ol Tabla de Contenido...