![background image](http://html.mh-extra.com/html/troy-bilt/700-series/700-series_operators-manual_1173400008.webp)
8
S
ection
3— A
SSembly
& S
et
-U
p
3.
Gently lift the handlebar and place the handlebar brace in
the desired height position on the handle mount bracket
and secure it in place with the star knob removed in Step 2.
See Figure 3-2.
4.
Locate the forward (black) and reverse (red) cables on the
right side of the handle. Remove any packaging material on
the cables being sure not to damage them.
5.
The forward (black) cable is routed up the back of the right
handle and connected to the clutch bail as shown in Figure 3-3.
Red
Black
Red
Black
Figure 3-3
6.
When the forward (black) cable is correctly connected
to the clutch bail, mount the cable in the cable mount
bracket. See Figure 3-3.
7.
The reverse (red) cable is routed up the right side of the
right handle and connected to the reverse handle as shown
in Figure 3-3.
8.
When the reverse (red) cable is correctly connected to
the reverse handle, mount the cable into the cable mount
bracket. See Figure 3-3.
9.
Route the wire harness up the back of the handle and
connect the harness to the ON/OFF switch on the
underside of the panel. See Figure 3-4.
Figure 3-4
10. Route the neutral cable up the left handle, through the slot
in the panel and hook it into the neutral handle. See Figure
3-5.
Figure 3-5
NOTE:
Be sure that the spring hook is routed from right to
left as shown in Figure 3-6 or the spring will hit the lever.
11. When the cable is properly hooked into the handle, snap it
into the cable mount bracket as shown in Figure 3-5.
Summary of Contents for 700 SERIES
Page 22: ...Notes 10 22 ...
Page 23: ...23 Section 10 Notes ...
Page 46: ...Notas 9 22 ...
Page 47: ...23 Section 9 Notas ...