![background image](http://html.mh-extra.com/html/troy-bilt/42010/42010_owners-operators-manual_1173244009.webp)
9
Section 2: Assembly
A
J
B
C
E
F
D
G
H
I
IMPORTANT: Left and right sides of the
unit are determined from the operator
position, facing the direction of forward
travel.
E. Install Handlebars
1. Cut the plastic cable ties securing the
handlebar ends to the chassis and
remove the handlebars. Remove the
protective wrapping on the handlebars.
2. Attach the handlebars to the sides of
the chassis as follows (use the four
3/8-16 x 3/4" hex flange screws
supplied in hardware bag):
a. Install two screws in the upper
mounting holes (C, Fig. 2-3) on
each side. Leave screws loose
enough to allow handlebar to pivot.
b. Install two screws (D) in the lower
mounting holes.
c. Using light pressure, press down on
the left side handlebar and tighten
the two screws. Repeat on the right
side handlebar.
3. There are four pre-installed screws
(E, Fig. 2-3) on the inside of the
handlebars that secure the control
panel to the handlebars. Check each
screw and tighten securely.
Fig. 2-2
Hardware shown full size.
C
D
E
E
Fig. 2-3