Troxler Enhanced RoadReader Plus 3451, Manual Of Operation And Instruction

Page: 83 / 247

4–20
✓
Reposition the gauge as prompted by the PDA and repeat the
above procedure at each position.
✓
After the final count is completed, the gauge collects the count
information and GPS data, and then transmits this data to the
PDA.
✓
The PDA displays the averaged measurement results as shown
in Figure 4–13. Press the
〈
ok
〉
button to continue.
NOTE
If the gauge is unable to obtain GPS data after taking a
count, it will still send the count results to the PDA and
the results will be stored in the active project.
Figure 4–12. Individual Count Figure 4–13. Averaged Count
Results, Thin Layer Mode Results, Thin Layer Mode