Wall installation
For restricted spaces you can detach the controller
from the VAV terminal unit and install it on the wall
next to the terminal unit or anywhere else nearby; to
fix the controller on a wall, you can use a mounting
bracket (Part no. E346GL3).
Do not extend the actuator cable or any measuring
tubes.
Be sure to install the controller according to the
sticker showing the correct installation orientations
.
Fig. 8: Detaching the controller
1.
Use a screwdriver to flip up the lug (1) and
lift the controller.
In some cases, e.g. with TVLK, the controller
is factory fitted to the terminal unit without a
bracket.
2.
Use suitable screws
∅
4 mm to fix the
mounting bracket to the wall.
3.
Press the controller casing as shown onto
the mounting bracket until it clicks into place.
Installation
EASYLAB controller Serie TCU3
19
