Trox Technik X-CUBE, Transport And Installation Manual

Page: 63 / 100

3. Check that the rotor moves freely.
See the manufacturer's documentation
Ä
Appendix A ‘Adjusting the storage mass’
on page 72.
4. Check the rotation direction of the rotor and
change it on the motor controller, if necessary.
Follow the manufacturer's operating instructions.
If the heat exchanger includes a purge sector,
the rotating storage mass passes from the
extract air via the purge sector to the supply
air.
5. Check that the control module functions correctly.
6. Check the drive belt tension.
7. Setting up the drive equipment, Ä ‘Setting up the
drive equipment’ on page 63 .
8. Check that the seals are tight; readjust them, if
necessary.
See the manufacturer's documentation
Ä
Appendix A ‘Adjusting the storage mass’
on page 72.
ð
The rotary heat exchanger has been set up.
Setting up the drive equipment
Personnel:

Skilled qualified electrician
Protective equipment:

Protective clothing

Hearing protection
 Industrial safety helmet

Protective gloves

Safety shoes
We recommend that you check the tension of the drive
belt regularly during the first 400 hours of operation.
1. Open the inspection access panel on the indicated
corner of the rotor casing.
2. Check whether the drive belt has sufficient ten-
sion; if necessary, shorten the belt as follows:
Shortening the drive belt
3. Open the lock.
4. Shorten the belt as required.
5. Close the lock.
6. Close the inspection access panel.
Checking the motor
7. Ensure that the motor is securely fixed.
ð
The drive equipment has been set up.
6.3.10 Plate heat exchanger
Setting up the plate heat exchanger
Personnel:

HVAC technician
Protective equipment:

Industrial safety helmet

Protective clothing

Protective gloves

Safety shoes
NOTICE!
Risk of damage to property from extreme pres-
sure drop!
An extreme pressure drop between the supply air
and extract air flows can damage the heat
exchanger.
– Ensure that the maximum differential pressure
(approx. 1000 Pa, depending on unit design) is
not exceeded.
– Check differential pressure on pressure monitors
according to the specified intervals.
Check and, if necessary, clean the plate heat
exchanger to remove foreign matter and contami-
nation.
ð
The plate heat exchanger has been set up.
Initial commissioning
Setting up and adjusting AHU casing units > Plate heat exchanger
Air handling unit X-CUBE 63