4
EN
submerged waste water pump TWP 4025 E / TWP 7025 E / TWP 11025 E
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Protect the power supply cable against heat, oil and sharp
edges.
•
Only use splash-proof extension cables intended for
outdoor use whilst observing the device's power input.
Before using cable drums, always unroll the cable
completely. Check the cable for damage.
•
Before performing any work on the device, in case of leaks
in the water system, before taking work breaks or when
not in use, remove the mains plug from the mains socket.
General safety warnings – Personal safety
•
Never use the device with persons or animals in the water
or pumping medium or if they could access it.
There is a
risk of electric shock!
•
Never insert any objects or limbs into the device.
•
This appliance is not a toy! Keep away from children and
animals. Do not leave the device unattended during
operation.
Device-specific safety warnings for submerged
pumps
•
Do not leave the device running unattended to ensure an
early detection of when the device runs dry or switches off
automatically. This would damage the device. Regularly
check the float for proper functioning.
•
Please bear in mind, that the device is not suitable for
continuous operation (e.g. for watercourses in garden
ponds). Check the device for proper functioning on a
regular basis.
•
Keep in mind, that lubricants are used within the device.
These might potentially cause damages or contaminations
if emitted. Do not use the device for drinking water or in
garden ponds with either a fish population or valuable
plants.
•
The device is not to be carried by holding it at the power
supply cable or hose. Do not fasten it there either.
•
Do not place any objects on the device – not even to
weight it down. The device will sink to the ground due to
its own weight.
•
After the set-up of the device, its mains plug must be
readily accessible during operation.
•
Wear sturdy shoes to protect yourself against electric
shock.
•
Before taking the device into operation, have the following
checked by an expert:
– earthing, neutral conductor and RCD must be
functioning properly and correspond to the national
regulations,
– electrical plug connections must be protected from
moisture.
•
Provide appropriate frost protection.
Intended use
The device
TWP 4025 E
/
TWP 7025 E
/
TWP 11025 E
is only
suited for draining, conveying and pumping over the following
media:
•
clear water and waste water
•
non-corrosive suds (e.g. leaking washing machine)
•
slightly chlorinated water
When doing so, the water must not contain any suspended
matter exceeding a maximum particle size of 25 mm.
The device is fully submersible (watertight encapsulation) and
can be immersed up to 5 m (
TWP 4025 E
) or 7 m (
TWP 7025 E
/
TWP 11025 E
) into the conveyed medium.
The water temperature must not exceed 35 °C.
The device may temporarily be used for e.g.:
•
pumping out flooded basements
•
emptying tanks and containers
•
the water withdrawal from wells and shafts