6
EN
floor fan TVM 11 / TVM 12 / TVM 13 / TVM 14 / TVM 17 / TVM 18 / TVM 20 D / TVM 24 D
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with a
transport handle.
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
After
transporting the device, proceed as follows:
•
Set up the device in an upright position after transport.
Storage
Before
storing the device, proceed as follows:
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
•
Store the device in a dry location and protected from frost
and heat.
•
If required, use a cover to protect the device from invasive
dust.
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and start-up
Scope of delivery
•
1 x device
•
1 x manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
The floor fan is supplied completely pre-assembled.
Setting the fan's inclination angle
The fans' inclination angles can be manually adjusted. The
individual inclination angles of the devices are provided in the
technical data.
1. Move the fan head forward or back so that it is slightly
inclined either to the front or to the rear.
ð
The fan's inclination angle has been set and the air will
flow out at the selected inclination angle.
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical annex.
Positioning
A
C
C
D
B
Warning
Risk of injury due to incorrect start-up!
There is a risk of injury if the protective grid is not
installed correctly around the impeller. The protective
grid must be installed correctly before the device is
switched on.
Warning
Risk of injury if protective grid is removed!
There is a risk of injury if the protective grid is removed
during operation. Do not remove the protective grid
while the device is in operation!