EN
5
dehumidifier TTK 900 MP
Residual risks
Danger
Refrigerant R454C!
H220 – Extremely flammable gas.
H280 – Contains gas under pressure; may explode if
heated.
P210 – Keep away from heat, sparks, open flames and
other ignition sources. No smoking.
P381 – Eliminate all ignition sources if safe to do so.
P403 – Store in a well-ventilated place.
Warning of electrical voltage
Work on the electrical components must only be
carried out by an authorised specialist company!
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket!
Do not touch the mains plug with wet or damp hands.
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Warning
Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!
Warning
The device is not a toy and does not belong in the
hands of children.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
Note
Do not operate the device without an air filter inserted
into the air inlet!
Without the air filter, the inside of the device will be
heavily contaminated. This could reduce the
performance and result in damage to the device.
Behaviour in the event of an emergency
1. Switch the device off.
2. In an emergency, disconnect the device from the mains
feed-in: Hold onto the mains plug while pulling the power
cable out of the mains socket.
3. Do not reconnect a defective device to the mains.
Information about the device
Device description
The device uses the principle of condensation to automatically
dehumidify rooms.
The fan sucks damp room air through the air inlet, the air filter,
the evaporator and to the condenser located behind it. The air is
cooled at the cold evaporator until it is below the dew point.
Water vapour contained in the room air precipitates on the
evaporator fins as condensation or rime. The dehumidified,
cooled air is slightly warmed at the condenser and blown out
again. The drier air thus conditioned mixes with the air in the
room. The humidity in the room where the device is positioned
is reduced as air constantly circulates through the device.
The condensate is discharged through a pressure-resistant pipe
connection by means of a condensation drain hose. For the
collection you can for instance place a sufficiently dimensioned
collection container beside the construction dryer.
Optionally, the condensed water can also be discharged from
the device by means of a retrofitted condensate pump (see
chapter Installing the condensate pump).
For easy operation and transport, the device is fitted with an on/
off switch, a ventilation level switch, an operating hours
counter, a transport handle and wheels. Two feet with rubber
buffers prevent the device from rolling away.
The device can reduce the relative humidity of a room to
approx. 35 %.
Because of the heat radiation generated during operation, the
room temperature may rise slightly.
The device is equipped with VarioDry technology. Using
VarioDry, the air volume flow can be adjusted to the
temperature and relative humidity of the operating environment.
