Trotec TTK 128 E, Operating Manual

Page: 7 / 16

EN
Operating Manual – Dehumidifier TTK 128 E
6
Operating elements
Switching the device on
1. Ensure that the condensation tank is empty and inserted
correctly. Otherwise, the device will not operate!
2. Insert the mains plug into a properly secured mains power
socket.
3. Open the fins at the air outlet (2).
4. Press the POWER button (14).
5. Press the SPEED button (15) to select the desired fan speed.
6. Press HUMIDITY SETTING (18) to set the desired humidity
level.
Setting the humidity level
Note:
The selected humidity value must not be higher than the current
humidity level in the room where the device is positioned.
The humidity level can be adjusted in steps of 5 % in the range
between 20 % and 90 %. The set humidity value is indicated on
the display (16).
• Press HUMIDITY SETTING (18) to set the desired humidity
level.
Selecting the fan speed
The fan speed setting can be adjusted to either high or low.
• Press the SPEED button (15) to select the desired fan speed.
– The indicator light HI (12) is illuminated at high fan speed.
– The indicator light LOW (11) is illuminated at low fan speed.
Continuous operation mode
In continuous operation mode, the device dehumidifies the air
constantly, regardless of the humidity in the air.
The condensate is collected in the condensation tank or drained
separately.
For separate draining, both a suitable hose (ø
½
") and a
sufficiently dimensioned collection container or drain are
required.
Start the continuous operation mode as follows:
1. Switch off the device.
2. If you want to drain the condensate separately, remove the
condensation tank (7) and carry out steps 3. and 4. If you
want to collect the condensate in the condensation tank,
proceed with step 5.
3. Connect a suitable hose (ø
½
") to the hose connector (6) and
introduce it into an appropriate condensate collection
container.
– Make sure that the container is located at a lower level than
the hose connector.
– During operation, make sure that the condensate collection
container does not overflow to avoid water damage.
4. Put the condensation tank (7) back in.
– In doing so, make sure not to crush the hose.
5. Press HUMIDITY SETTING (18) until "CO" is displayed.
– The dehumidifier now works in continuous operation mode.
No. Designation
8 DEFROST indicator light
9 TANK FULL indicator light
10 TIMER indicator light
11 Indicator light LOW
12 Indicator light HI
13 Indicator light OPERATION
14 POWER button
15 SPEED button
16 Display
17 TIMER button
18 HUMIDITY SETTING button
10
16
9 8
17 18 15 14
13 12 11