4
Operating Manual – Radial Fan TFV 900
EN
• Remove all packing materials which serve to protect the
device during transport.
• Should the device be damaged, please contact the
responsible dealer or manufacturer, where the purchase was
made.
• The device with frame may only be lifted at the points
provided with lifting gear (forklift pockets (6), crane lifting
lugs (2)).
The carrying capacity of the lifting gear must be suitable for
the weight of the device (see Technical data).
• The device without frame may only be lifted at the lifting lugs
provided at motor and fan. The carrying capacity of the lifting
gear must be suitable for the weight of the device (see
Technical data).
• For transport with a forklift drive in from the motor side, that's
where the centre of gravity is to be found. The other forklift
pockets are for the later fine adjustment on site.
• Only wheel the device with frame on firm, level ground. Make
sure that nobody is situated in the direction of movement.
Avoid pulling the device, this increases the risk of tripping
and injury.
The following should be observed
before
transporting the device
using the
castors
:
Caution!
Trip hazard! Make sure that nobody is situated in the
immediate proximity.
The following should be observed
before
transporting the device
using
lifting gear
:
Danger!
Risk of injury from suspended loads. Make sure that
nobody is situated in the immediate proximity.
• Only instructed persons are allowed to perform the transport
by use of lifting gear.
• Consider the centre of gravity when transporting the load.
Storage
• Store the cleaned device in a dry location and protect it
against dust.
• Before restarting the device, check the power cable for
perfect condition.
Installation of the device
• Position the device on firm, dry and level ground. Depending
on the permissible floor load capacity a panel for weight
distribution may be required.
• When setting up the device, ensure a sufficient distance for
air inlet and outlet as well as for operation (see Technical
data).
• Ensure that extension cords are completely unrolled.
• Option with frame:
Apply the parking brakes prior to
start-up
and secure the device against rolling away.
The following points are to be checked
before
start-up:
• Make sure that both air inlet and air outlet are free from
objects and/or obstacles.
• Manually check the freewheeling of the fan:
– Carefully rotate the rotor by hand, it should not rub against
the housing.
• Connect the required air transport hoses with suitable tension
belts with clamping lock to the air intake connection (8) or as
needed to the air exhaust connection (5).
• Compare the values of the power connection to the technical
data of the TFV 900. Observe the starting current of the
device, the upstream fuse must be dimensioned accordingly.
• Before connecting the device to the mains, check the rotary
field:
clockwise rotating field
required!
• First connect the fan plug to the power cable and then the
cable to the distribution!
Transport and storage
Start-up
